Byteplant Forum

Home » CleanMail Support » CleanMail Server Talk » Install problems
Install problems [message #1780] Fri, 27 July 2007 15:17
Chris
Messages: 1
Registered: July 2007
Junior Member
I have 2 Windows server 2003 servers. One is the Exchange server, one is a file server. Yesterday I installed the NST for servers on the file server, and went through all the options and settings for it. The relay worked fine, everything seemed good. All I had to do was change the router to send the SMTP to the file server instead of the Exchange server. Since I had updates to install, I took the network down and rebooted both servers and the router. After the servers came up, the relay would not work any more. I get an error in NST - (connect) connection aborted. All I did was run some microsoft updates and rebooted the server. I uninstalled the software and reinstalled, still the same issue. What do I need to do now, to get the software to work again?
Re: Install problems [message #1781 is a reply to message #1780] Fri, 27 July 2007 17:34 Go to previous message
support
Messages: 918
Registered: April 2004
Senior Member
Make sure Exchange is till listening on the outgoing IP/port you configured in NoSpamToday!

Use the "Test" button in the SMTP port setup dialog to send a test message, and see if it works.



Customer Support
Byteplant GmbH
Previous Topic: Service crash
Next Topic: Blacklist/Whitelist gone from Spamassassin GUI config
Goto Forum:
  


Current Time: Mon Sep 26 10:45:58 CEST 2016